This document will walk you through installing and running the essential EdgeX Foundry microservices on a RaspberryPi for testing and evaluation. This is not an officially supported way of running EdgeX Foundry, and should not be used in a production environment. This guide is for developers who want to learn EdgeX by running it as a mock gateway device.

...

The RaspberryPi 3B+ has a full gig of ram, but between building the EdgeX Foundry source code and running MongoDB this may not be enough. So before going any further you will first want to create some additional memory capacity by adding a swap file to your filesystem. Run the following command to create a new 2GB swap file:

sudo touch /tmp/theswap
sudo chmod 600 /tmp/theswap
sudo dd if=/dev/zero of=/tmp/theswap bs=1M count=2048
sudo mkswap /tmp/theswap 
sudo swapon /tmp/theswap

Install Go & Glide

...